Product Information
Availability
In Stock
Seller
Alightings
About this item
- Reusable Clip Without Ruining Your Strip: Most solderless clip connectors pierce the copper pad on contact, so a wrong-side-up or reverse-polarity clip usually means cutting that section away and rejoining with a fresh piece of strip. This flip-latch design clamps with even, controlled pressure instead of piercing — if you clip it in wrong, just lift the white latch, flip the strip, and reconnect the same section instead of cutting it out
- Indoor Cabinet, Closet, and Vanity Installs: Clips onto 8mm LED tape inside kitchen cabinets, under bathroom vanities, along bookshelf edges, or behind TV panels without a soldering iron or screwdriver. Rated IP20 for dry indoor locations; a flame-retardant polycarbonate housing surrounds the contacts
- Works with IP65 Silicone-Coated Strips: For waterproof 8mm tape, peel back the silicone coating over the two copper pads with a fingernail or plastic tool before inserting; non-waterproof strips insert directly with no prep step needed
- Pairs with 8mm Single-Color Tape and a DC Power Adapter: Each connector links 3528 or 2835 tape to a 12V or 24V DC power source using 22-20 AWG extension wire cut to the run length. This 10-pack covers multiple cabinet runs with spare connectors left over for polarity corrections
- 6A Rating, 5V-24V DC Compatibility : Handles single-color 3528 and 2835 LED tape rated up to 6A across the 5V-24V DC range. The wire slot fits 22-20 AWG solid or stranded two-conductor cable, so existing extension wire on hand will usually work. Not compatible with RGB, 4-pin, 5-pin, or 10mm-wide strips
