BerleyPro Kayak EMB — Electronics Mounting Board for Kayak Hull — 6mm HDPE, Hobie Mast Clip Mount, Pre-Drilled for Tidy Wiring — Suits LiveScope, ActiveTarget, Power Hubs — Made in Australia

Product Information

About this item

• KEEPS ELECTRONICS OFF THE HULL FLOOR — PROTECTS AGAINST WATER INGRESS – Mounts your electronics modules inside the hull, elevated off the bottom. Water gets into kayak hulls — keeping modules, distribution hubs, and regulators raised off the floor reduces the risk of water damage to expensive electronics.
• CLIPS TO THE HOBIE MAST MOUNT — NO DRILLING, TOOL-FREE INSTALL AND REMOVAL – Includes 2 mast clips that clip directly around the Hobie kayak mast mount inside the hull. No drilling into the hull required. Removes cleanly for access or reconfiguration.
• PRE-DRILLED WITH HOLES FOR TIDY WIRING – Multiple pre-drilled holes and routing slots allow cables to run neatly through and behind the board. Keeps wiring off the hull floor and out of standing water.
• SUITS LIVESCOPE, ACTIVETARGET, NEMA HUBS, POWER DISTRIBUTION HUBS, AND REGULATORS – Sized and drilled to suit the surface-mount electronics commonly used in Hobie kayak setups. Anglers running full forward-facing sonar rigs use it to mount the black box, YakPower relay, and battery regulators in a single organised install.
• 6mm BLACK HDPE — MADE IN AUSTRALIA – Cut from 6mm black HDPE plate. Resistant to water, salt, and UV. Won't corrode, rust, or degrade inside a hull. Includes 2 mast clips. Made in Australia.

Product Description

Electronics mounting board for inside kayak hulls. Mounts to the Hobie mast mount using the included mast clips — no drilling required. Elevates electronic modules, power distribution hubs, and wiring off the hull floor and out of standing water.What it's for:Mounting LiveScope or ActiveTarget black boxes inside the hullSecuring NEMA hubs, power distribution hubs, and battery regulators off the hull floorOrganising and routing cables through pre-drilled holes and wiring slotsKeeping electronics elevated in hulls where water ingress is a riskHow it installs:2 mast clips included — clip directly around the Hobie mast mount inside the hullNo drilling into the hull requiredTool-free install and removal for access or reconfigurationSpecifications:Material: 6mm black HDPEIncludes: 2 mast clipsPre-drilled with holes and wiring slotsMade in AustraliaDesigned primarily for Hobie kayaks with mast mounts. May suit other kayaks with compatible internal mast or mounting structures.