XQSMWF 2 Pcs Bumper Parking Sensor Cover 28533-5ZA0A Compatible with Nissan Altima Armada Murano Fit for Infiniti Q50 Q60 Q70 2015 2016 2017 2018 2019 2020

Product Information

About this item

• FITMENT CONFIRMATION: Fit for Nissan Altima 2015-2018, Fit for Nissan Armada 2017-2020, Fit for Nissan GT-R 2017-2020, Fit for Nissan Maxima 2016-2018, Fit for Nissan Murano 2019-2020, Fit for Infiniti Q50 2018-2020, Fit for Infiniti QX50 2016-2020, Fit for Infiniti Q60 2017-2020, Fit for Infiniti QX60 2016-2020, Fit for Infiniti Q70 2015-2019, Fit for Infiniti Q70L 2015-2019, Fit for Infiniti QX80 2015-2020. This is the outer sensor COVER/BRACKET only — it does NOT include the parking sensor itself. It snaps into the factory sensor hole in the front or rear bumper.
• PART NUMBER COMPATIBILITY: Replaces 28533-5ZA0A, 285335ZA0A. This parking sensor cover is the outer housing/bracket that holds the ultrasonic parking sensor in place within the bumper. It snaps directly into the factory sensor mounting hole with no modification required. The cover is designed to allow ultrasonic sound waves to pass through while shielding the sensor from direct impacts. We strongly recommend verifying this part number with your old cover before ordering — take out the old cover and check the number stamped on the back side. This cover does NOT fit vehicles that use the larger 28438-series sensor housings.
• ENGINEERED FOR PERFORMANCE: Manufactured from automotive-grade ABS plastic with reinforced snap-fit retention tabs that hold securely in the bumper mounting hole. The cover is precision-molded to sit flush with the bumper surface. The internal geometry holds the sensor at the correct angle for proper detection range.
• CONFIDENCE IN YOUR PURCHASE: Common reasons for replacement: cover cracked or broken from minor impact, cover fell out due to broken retention tabs, cover missing after bumper repair, cover faded or discolored, or cover warped from heat exposure. This 2-piece set provides a spare for future use or allows both sides to be replaced at once.
• EASY INSTALLATION: Step 1: Locate the sensor mounting hole in the front or rear bumper. Step 2: If the old broken cover is still in place, use needle-nose pliers to take out remaining pieces. Step 3: Align the replacement cover with the sensor hole — fits one way only. Step 4: Press firmly until you hear a click — confirms retention tabs are engaged. Step 5: Verify the cover sits flush with the bumper surface. No tools required.