One N Done 400DS Toilet Flange Repair Kit – Deepest Seal – Diamond Saw

About this item

• NO-GUESS / NO-MESS FLANGE REPAIR — This toilet flange repair kit combines the ONLY Self-Adjusting wax-free toilet seal with a repair ring for low, damaged or broken toilet flanges. It handles toilet wax ring replacement and flange repair in one kit without guessing seal thickness or stacking extra gaskets. The Deepest One N Done toilet seal adjusts to any toilet flange depth.
• UNIVERSAL ALL-DEPTH FIT — One self-adjusting wax-free toilet gasket fits all flange depths. No extra toilet gasket or stacked seal is ever needed. Low toilet flange? The Deepest Seal handles flange positions down to approximately 1.5 inches below the finished floor without a separate toilet flange extender. The 400 repair ring adds flange-repair capability for low, damaged or broken toilet flanges.
• EASY INSTALL — DIAMOND SAW + LOCKING NYLON BOLTS — Reinforced nylon toilet flange bolts tighten by hand, lock into the One N Done flange and will never spin freely during installation. The included Diamond Saw trims excess bolt length in tight spaces near walls or cabinets. Lock Nuts hold the bolts upright and help center the seal, flange and toilet for easier alignment. The 400 repair ring secures with six flange screws for a strong, secure installation.
• REUSABLE WAXLESS TOILET RING — Unlike a traditional wax ring for toilet installations, the One N Done wax-free toilet seal can be repositioned and reused if you need to lift or reset the toilet during installation. The self-adjusting gasket springs back after compression for reuse, so you don’t have to start over with a new wax ring after repositioning.
• LOCKING TOILET BOLT CAPS + TOILET SHIMS — Low-profile white toilet bolt caps install with a quarter-turn to lock in place after trimming. These locking toilet bolt covers help keep the caps from being knocked loose and create a clean finished installation. High toilet flange or uneven floor tile causing the toilet to rock? Included toilet shims help level and stabilize the toilet.
• Note: Toilets with concert subfloors may require a hammer drill and anchors. If toilet flange spacer was installed and extend the top surface of the toilet flange over 1/8 inch above the floor, the 1/4 inch extension will need to be removed for the One and Done toilet repair flange to properly fit.
• Note: If the holes do not line up with existing holes in toilet flange the flange can be drilled to align with existing flange holes or the old flange can be drilled to match the One-N-Done Flange hole openings.