RFX-10205 Cable Railing Kit, 5 ft of 1/8" Cable with 2-7/8" Pre-Swaged Threaded Stud and Pull-Lock, for Stairs, Level or Pitched Runs, Suitable for Wood or Metal Posts

About this item

• The Classic (Basic 102) Series kit is offered with cable length 5 ft. Each kit contains the cable and hardware needed to complete one run.
• A through-the-post configuration is the ideal scenario to use the Classic (Basic 102) threaded stud cable kits. The threaded studs are a functional fitting, not a hide-in-the-post solution. A brass hex nut and some metal thread (both covered by an end cap) will extend beyond the back of the post on one end. A Pull-Lock fitting is installed through the other end.
• For either wood or metal posts, use the Classic (Basic 102) Series. The tensioning device is a 2-7/8” long threaded stud which installs on the back side of one end post.
• When taking cable railing through a corner, do not bend the cable past 45⁰ at any one time. If turning 90⁰, a 2-step turn using a double corner post configuration is required.
• Tools Required for Installation: 7/32″ Drill Bit; 1/4″ Drill Bit; 1/2″ Drill Bit; 1/8″ Hex Wrench; 7/16″ Wrench; RFXPL-KEY; Cut Off Kit (mandrel); Cut Off Kit (wheel); Pre-Tensioning Block; Lacing Needle
• Order our Installation Kit along with your Cable Kit to ensure you have the required tools needed. Use the Part Number INSTL-KIT-100_200