Lichaser 3.3FT USB COB LED Strip Light, 6 Rolls LED Lights for Wood Slat Wall Panels and Acoustic Panel Parallel with Dimmable Touch Sensor, Flexible 3000K COB Strip Cuttable for Shelves, Cabinet

Product Information

About this item

• 6 Rolls of 5V USB COB light strip for acoustic panels in parallel: 6 rolls of 3.3 ft / 6.6 ft LED strip COB installed in parallel and controlled by a single sensor, the number of light beads is dense, allowing high brightness and low energy consumption, creating a warm and welcoming environment, suitable for acoustic panel lighting, wood slat wall panel, showcase lighting, cabinet, kitchen lighting and shelf lighting other indoor scenes
• Hand-scanning and touch sensor switch: The sensor comes with adhesive. Stick the sensor to the partition (≤ 0.8 in). You can control the COB LED strip by touch and hand-scanning. A short press controls the COB LED to turn on and off, while a long press adjusts the brightness of the warm white LED strip, very convenient. Meanwhile, the sensor has a memory function that saves you time for resetting
• Hidden sensor switch: The sensors are suitable for slats wall panels, cabinets, display cases, and others that require hidden sensor switches. You can stick them to the back of wooden partitions or glass mirrors without opening any holes! Note: The thinner the partition, the higher the control sensitivity. It is recommended that the control range of the partition be within 0.8 in. Keep it away from metallic materials
• Cuttable & Self-adhesive COB LED strip light: The COB LED strip acoustic panels are equipped with strong adhesive tape, making installation significantly easier and more straightforward. Before applying the COB LED, you should thoroughly clean the surface to ensure optimal adhesion of the adhesive tape. The strip can be cut along the centerline of the 2-pin copper piece, allowing you to cut it according to your installation requirements
• Note: ① Do not install the sensor on metallic materials to avoid interference. ② For higher sensitivity, a partition thickness of ≤ 0.8 in is recommended. ③ When cutting, cut along the center line of the 2-pin copper sheet and disconnect the power supply before cutting. ④ Please do not repeatedly stick the backing material to prevent the adhesive from deteriorating