Photography Ceiling Rail, 21.7-78.7 Inch Height Adjust, Pulley 22 Lbs Load

Product Information

About

[78.7 Inches Of Vertical Play Room]: Height sweeps from 21.7 to 78.7 inches, so overhead washes and close directional keys both live on one rail. Studios of nearly any ceiling height fit, and no ladders interrupt the shoot ever again, every setup getting its mark.
[22 Lbs Of Gear Hangs Confident]: The reinforced base carries up to 22 lbs, holding panel lights, spotlights, or flash units with margin. Verify your fixture weight before ordering, as the notes advise, and rig with safety first on every single setup.
[Standard Connector Swaps Fixtures]: The standard connector accepts most panel lights, spotlights, and flashes, so fixture changes take seconds between setups. One rail serves the whole kit, you rent less gear, and the budget stretches across the shooting calendar.
[Steel Wire Glides Without Jerks]: Reinforced steel wire runs through the pulley system, raising and lowering fixtures in one smooth, controlled glide. No creaks, no jerks, no dropped keys, and the adjustment stays invisible on camera, always.
[Wire Clips End The Cable Chaos]: Included wire clips route cords along the rail, keeping cables off the floor and out of every frame. Trip hazards vanish, shot integrity rises, and clients notice the tidy set instantly, before they even say a word.
[Sprayed Finish Shrugs Off Studio Life]: The spray-plastic coated aluminum and iron build resists the scrapes of busy sets. Years of clamps, cases, and carts leave nothing that matters, and upkeep stays a quick wipe between shoots, shoot after shoot.
[Lights Not Included, Rail Ready]: Lights are not included, the listing states plainly, so budget for fixtures while this rail handles the suspension duty. Expansion screws expanding under force is normal behavior, and confirming size plus load before ordering avoids surprises.